|
South Coast Harley-Davidson is available to serve your needs for a Motorcycle Repair and this business may provide services like Motorcycle Repair in the Chula Vista residential area. From our local Chula Vista contacts, we have confirmed their fluency in English and that they have the required communication skills for Motorcycle Repair work. South Coast Harley-Davidson is always accessible via phone (Phone: 6194207000) and we found them prompt
(Note, if you contact them using our above form then you will get benefits of GetVendors.com service guarantee program as well)
South Coast Harley-Davidson has done some good work of motorcycle mudguard replacement and motorcycle brake light replacement in our Chula Vista neighbohood.South Coast Harley-Davidson has specialities in motorcycle collision repair and repair motorcycle wheel misalignment.
In summary,
I refer you South Coast Harley-Davidson because I found it up front and market savvy.
For your reference, here are some key service details about South Coast Harley-Davidson,
| Hours of Operation: |
Monday to Friday (9 AM to 6 PM) |
Looking at the resources and people available with South Coast Harley-Davidson, they can be a good choice for Motorcycle Repair, if you live in Chula Vista zip codes 91912, 91914, 91915, 91910, 91913, 91909, 91921, 91911.
Motorcycle Repair Project Matches
Requirement Posted- 2007-09-16 15:09:10.0 Location- Marina del Rey, CA 90292 Details- collision repair
Requirement Posted- 2007-04-05 10:53:15.0 Location- San Diego, CA 92124 Details- Motorcycle Repair. Broken exhust bolt
Requirement Posted- 2007-03-13 07:38:34.0 Location- Oceanside, CA 92057 Details- leacking oil. need minor body repair
Requirement Posted- 2007-03-04 12:56:54.0 Location- San Diego, CA 92124 Details- electrical wires from ignition were cut completely off, need to repair
Requirement Posted- 2007-02-25 16:48:06.0 Location- San Diego, CA 92129 Details- 1976 honda xl175, minor problems except for my lack of motorcycle knowledge.
Requirement Posted- 2007-02-17 13:30:17.0 Location- Chula Vista, CA 91911 Details- crashed 2003 yamaha r6, needs minor work and tune up, been sitting for a while
Requirement Posted- 2007-02-02 09:52:53.0 Location- San Diego, CA 92108 Details- I need 2 blinkers wired and mounted to the front of my Honda CBR600 F4. Also a connector for the back turn signal and a battery check to see if the battery is holding its charge.
|
I have a 93' Yamaha Venture 1300 and I have brake problems (no back brakes) I was bleeding the back caliper and I found it was leaking. I replaced it (new) and also replaced the brake fluid. I bled the system but now the back caliper will not release. I can loosen the brake line at the proportioning vlv and they release. so this eleminates the brake line and the caliper I removed the rear master cylinder and cleaned as well as checked all ports as well as the bleed hole in the main piston bore and all was clean. I believe it has something to do with the porportioning valve that actually feeds the back brakes. I dis-assembled it an inspected, other than not knowing how it operates, all looks well . re- installed with same results. Can yall give me some advise on this matter. ^P.S. my front left brake works & releases fine which are tied into the same Master Cyl but the front do not go though the rear Proportiong vlv